Pre-Transfer Charging Assembly; Transfer/Separation Charging; Assembly - Canon NP6085 Service Manual

D. Pre-Transfer Charging

Assembly

1. Removing the Pre-Transfer Charging

Assembly

1) Open the front doors.
2) Slide out the duplexing unit, and remove the
process cover.
3) Remove the mounting screw q, and pull out
the pre-transfer charging assembly e.
1
Figure 4-519
COPYRIGHT © 1996 CANON INC.
2
3
CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
E. Transfer/Separation Charging
Assembly
1. Removing the Transfer/Separation Charging
Assembly
1) Open the front door.
2) Slide out the duplexing unit, and remove the
process cover; then, set the duplexing unit to
the copier once again.
3) Insert a long screwdriver into the hole in the
stay at the front of the feeding assembly; then,
slide out the duplexing unit while lifting the
feeding assembly.
4) Remove the two mounting screws q, and
remove the charging assembly stopper plate
w; then, pull out the transfer/separation charg-
ing assembly.
1
Figure 4-520
2. Installing the Transfer/Separation Charging
Assembly
Install the charging assembly while the clean-
er drive block mounted to the charging assembly
rail of the feeding assembly is at the front.
If the cleaning drive block is not at the front,
while keeping the charging assembly outside,
select 'adjust/clean', 'wire cleaning', and then
'start' to execute wire cleaning; when the wire has
been cleaned, install the charging assembly.
Caution:
In case of installing the charging assembly,
be sure the charging assembly is set com-
pletely then, install the stopper plate.
4. MECHANICAL SYSTEM
2
4-71