Table of Contents
Advertisement
Chapter 3
Installation
Figure 3-20 Installing a Network Control Board in an ONS 15252 MCU
Step 3
Tighten the NCB module thumbscrews.
Procedure: Install the Communication Interface Module in the ONS 15252 MCU
Step 1
Align the CIM with the slot directly below the NCB module.
Step 2
Carefully insert the CIM into the slot and lower guide rail, making sure that no fibers are pinched in the
process. Be sure the CIM connector and the backplane connector mate correctly.
Step 3
Use a slot or Phillips screwdriver to tighten the CIM retaining screws.
Figure 3-21
78-13765-01
shows the CIM installed in the ONS 15252 MCU.
Cisco ONS 15200 Installation, Setup, and Test Manual
3-29
Advertisement
Table of Contents
