Log Into Fdm; Complete The Initial Configuration - Cisco Firepower 1010 Getting Started Manual

Log Into FDM

Enter a fully qualified hostname for this system [firepower]: ftd-1.cisco.com
Enter a comma-separated list of DNS servers or 'none' [208.67.222.222,208.67.220.220]:
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: yes
>
Step 4
Log into FDM on the new Management IP address.
Log Into FDM
Log into FDM to configure your FTD.
Before you begin
• Use a current version of Firefox, Chrome, Safari, Edge, or Internet Explorer.
Procedure
Step 1 Enter the following URL in your browser.
• (7.0 and later) Inside (Ethernet1/2 through 1/8)—https://192.168.95.1.You can connect to the inside
• (6.7 and earlier) Inside (Ethernet1/2 through 1/8)—https://192.168.1.1.You can connect to the inside
• (6.6 and later) Management—https://management_ip. The Management interface is a DHCP client, so
• (6.5 and earlier) Management—https://192.168.45.45. If you changed the Management IP address at
Step 2 Log in with the username admin, and thedefault password Admin123.
What to do next
• Run through the FDM setup wizard; see

Complete the Initial Configuration

Use the setup wizard when you first log into FDM to complete the initial configuration. After you complete
the setup wizard, you should have a functioning device with a few basic policies in place:
Cisco Firepower 1010 Getting Started Guide
36
All manuals and user guides at all-guides.com
address on any inside switch port (Ethernet1/2 through 1/8).
address on any inside switch port (Ethernet1/2 through 1/8).
the IP address depends on your DHCP server. If you changed the Management IP address at the CLI
setup, then enter that address.
the CLI setup, then enter that address.
Firepower Threat Defense Deployment with CDO
Complete the Initial Configuration, on page 70.