1.9 Traffic Card LED Activity
Table 1-13
Alarm
Facility Lpbk
FE Lpbk
FE Common Equipment Failure No
FE Equipment Failure-SA
FE LOS
FE LOF
FE AIS
FE IDLE
FE Equipment Failure-NSA
1.9 Traffic Card LED Activity
ONS 15310-CL and ONS 15310-MA card LED behavior patterns are listed in the following sections.
1.9.1 Typical Controller Card or Ethernet Card LED Activity After Insertion
When a traffic card is inserted, the following LED activities occur:
1.
2.
1.9.2 Typical Card LED Activity During Reset
When a traffic card is inserted, the following LED activities occur:
1.
2.
1.10 Frequently Used Alarm Troubleshooting Procedures
This section provides procedures that are frequently used when troubleshooting alarms. Most of these
procedures are summarized versions of more detailed procedures found in the Cisco ONS 15310-CL and
Cisco ONS 15310-MA Procedure Guide. They are included in this chapter for the user's convenience.
For further information, please refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA Procedure
Guide.
1.10.1 Protection Switching, Lock Initiation, and Clearing
The following sections give instructions for port and span switching and switch-clearing commands, as
well as lock-ons and lockouts.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-148
DS-1 Alarms by Line Type (continued)
The ACT LED blinks once and turns off for 5 to 10 seconds.
The ACT LED turns on.
The ACT LED blinks once and turns off for 5 to 10 seconds.
The ACT LED turns on.
UNFRAMED
D4
Yes
Yes
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Chapter 1
Alarm Troubleshooting
ESF
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
78-17235-01