Installing the HEPA-filter and the water reservoir cover
panel
The HEPA-filter
airbox rests on the water reservoir cover panel
1
2
Figure 4-4. Assembling the HEPA-filter and the airbox
1. Place the HEPA-filter
2. Tilt the airbox
corresponding slots provided in the HEPA-filter
3. Insert the tabs
(6/Figure
4. Place the seal
it down evenly.
Thermo Scientific
(2/Figure
4-4) must be inserted into the airbox
5
6
7
8
(2/Figure
4-4) on a flat surface.
(1/Figure
4-4) to the left and insert the tabs on the left
(5/Figure
4-4) on the right side of the airbox into the HEPA-filter catches
4-4).
(8/Figure
4-4) into the groove
Installing the HEPA-filter and the water reservoir cover panel
(2/Figure
4-5) and is pushed against the air intake.
3
4
(4/Figure
(7/Figure
4-4) provided at the airbox tubing and press
(1/Figure
4-4) from below. The
4
CLICK
(3/Figure
4-4) into the
4-4).
i160 / i250
S
TERI-CYCLE
4
Start-up
3
4-5