Toyota Celica 2005 Repair Manual page 679

DI−480
1 Check resistance of crankshaft position sensor.
Component Side:
Crankshaft Position Sensor
Front View
OK
2 Check for open and short in harness and connector between ECM and
crankshaft position sensor (See page IN−30).
OK
3 Inspect sensor installation.
CHECK:
Check the crankshaft position sensor installation.
OK
2005 CELICA (RM1131U)
DIAGNOSTICS − ENGINE (2ZZ−GE)
(a) Disconnect the crankshaft position sensor connector.
(b) Measure the resistance between the terminals of the
crankshaft position sensor connector.
OK:
Tester Connection
NOTICE:
A21267
"Cold" and "Hot" shown above mean the temperature of
the coils themselves. "Cold" is from −10_C (14_F) to 50_C
(122_F) and "Hot" is from 50_C (122_F) to 100_C (212_F).
NG Replace crankshaft position sensor.
NG Repair or replace harness or connector.
NG Tighten sensor.
678
1 − 2
Specified Condition
1,630 to 2,740 Ω at cold
2,065 to 3,225 Ω at hot