Panasonic FP-E Programming Manual page 179

4. When X0 is in the on state, the BRK instruction is executed and program execution stops.
5. Press the "F3" key while holding down the "Shift" key in the MONITOR & TEST RUN window of
the programming tool software to continue the program execution.
If a BRK instruction is executed, program execution stops.
X1
13
X12
35
(BRK)
6. Up to the end of the program, proceed according to the operation in steps 4 and 5 above.
If you want, change to the step operation mode, in which the program stops execution after
execution of each instruction.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Y31 Starts from the address 13
Execution
Stops at the address 35
Basic Instructions
2 − 69