Panasonic FP-E Programming Manual page 296

High−level Instructions
Explanation of example
The contents of data register DT0 are copied to the block ranging from data register DT10 to DT14 when
trigger R0 turns on.
K 10
DT0
K 11
[S] DT1
DT2 K 12
K 13
DT3
DT4
K 14
R0: on
DT0
K 10
[S] DT1
K 11
DT2
K 12
DT3
K 13
DT4
K 14
Description
The 16-bit equivalent constant or 16-bit area specified by S is copied to all 16-bit areas of the block specified
by D1 and D2.
Precautions during programming
The starting area D1 and ending area D2 should be the same type of operand.
The area of the lower address for the block being copied should be specified by D1, and the higher address
should be specified by D2. If D1 is specified as higher than D2 and the instruction is executed, an operation
error will occur.
When the same number as D1 and D2 is specified, the 16−bit data will be copied to the 16−bit area of that
number.
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
3 − 32
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
K 0 [D1]
DT10
K 0
DT11
K 0
DT12
K 0
DT13
[D2]
K 0
DT14
"F11 (COPY)" execution
[D1]
DT10 K 11
DT11 K 11
DT12
K 11
DT13
K 11
[D2]
DT14
K 11
Turns on and stays on when:
Turns on for an instant when:
− The area specified using the index modifier exceeds the limit.
− D1 > D2.