Syslog, Cdr And Debug Parameters - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 60 Configuration Parameters Reference
'Test Call DTMF String'
configure troubleshoot >
test-call settings >
testcall-dtmf-string
[TestCallDtmfString]
'Test Call ID'
configure troubleshoot >
test-call settings >
testcall-id
[TestCallID]

Syslog, CDR and Debug Parameters

The Syslog, CDR and debug parameters are described in the table below.
'Enable Syslog'
configure troubleshoot
> syslog > syslog
[EnableSyslog]
'Syslog Server IP'
configure troubleshoot
> syslog > syslog-ip
[SyslogServerIP]
'Syslog Server Port'
configure troubleshoot
> syslog > syslog-port
[SyslogServerPort]
Table 60-17:SIP Test Call Parameters
Parameter
Table 60-18:Syslog, CDR and Debug Parameters
Parameter
Defines the DTMF tone that is played for answered test
calls (incoming and outgoing).
The DTMF string can be up to 15 strings. The default is
"3212333". If no string is defined (empty), DTMF is not
played.
Defines the test call prefix number (ID) of the simulated
phone on the device. Incoming calls received with this
called prefix number are identified as test calls.
This can be any string of up to 15 characters. By default,
no number is defined.
Note: The parameter is only for testing incoming calls
destined to this prefix number.
Description
Determines whether the device sends logs and error
messages (e.g., CDRs) generated by the device to a
Syslog server.
■ [0] Disable (default)
■ [1] Enable
Note:
■ If you enable Syslog, you must enter an IP address of
the Syslog server, using the [SyslogServerIP]
parameter.
■ Syslog messages may increase the network traffic.
■ To configure Syslog SIP message logging levels, use
the [GwDebugLevel] parameter.
Defines the IP address (in dotted-decimal notation) of the
computer on which the Syslog server is running. The
Syslog server is an application designed to collect the logs
and error messages generated by the device.
The default IP address is 0.0.0.0.
Defines the UDP port of the Syslog server.
The valid range is 0 to 65,535. The default port is 514.
- 892 -
Mediant 4000 SBC | User's Manual
Description