Table of Contents
Advertisement
4 Configuration
Port (1-65535): Specifies the Port number. The range is between 1 and 65535 with the well-known default is
80.
System > Telnet Settings
Telnet configuration is Enabled by default. If user does not want to allow the Telnet configuration, they only
need to disable the Telnet State.
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the Telnet protocol is 23.
System > Password Encryption
The Password Encryption page is used to enable or disable the password encryption state. Select Enabled
and click Apply to make effect.
System > Ping Test
The Ping Test is a small program that sends ICMP Echo packets to the IP address you specify. The
destination node then responds to or "echoes" the packets sent the Switch. This is very useful to verify
connectivity between the Switch and other nodes on the network.
The user may use Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program
to keep sending ICMP Echo packets to the specified IP address until the program is stopped. The user may
opt to choose a specific number of times to ping the Target IPv4 or IPv6 Address by clicking its radio button
and entering a number between 1 and 255. Click Start to initiate the Ping Program
Timeout: Specify the timeout time of Ping test. The range is between 1 and 99 seconds.
DES-1210/ME Series Metro Ethernet Managed Switch User Manual
Figure 4.38– System > Web Settings
Figure 4.39 – System > Telnet Settings
Figure 4.40 – System > Password Encryption
Figure 4.41 – System > Ping Test
2
2
9
9
Advertisement
Table of Contents
