Ping - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
TFTP Server IP
Destination File
Log Type
Click the Backup button to initiate the system log backup.

Ping

Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then
responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch
and other nodes on the network.
To view the following window, click Tools > Ping, as shown below:
The fields that can be configured in IPv4 Ping are described below:
Parameter
Target IPv4 Address
Domain Name
Ping Times
Timeout
Source IPv4 Address
Description
Select and enter the IP address of the TFTP server here.
• IPv4 - Specifies to select and enter the IPv4 address of the TFTP server.
• IPv6 - Specifies to select and enter the IPv6 address of the TFTP server.
Enter the filename and path of the log file that will be stored on the TFTP sever
here. This field can be up to 64 characters long.
Select the log type on the Switch that will be backed up to the TFTP server here.
Options to choose from are System Log and Attack Log.
Figure 13-16 Ping Window
Description
Select and enter an IP address to be pinged.
Select and enter the domain name of the system to discover.
Enter the number of times desired to attempt to Ping the IPv4 address configured
in this window. Users may enter a number of times between 1 and 255.
Tick the Infinite check box to keep sending ICMP Echo packets to the specified
IP address until the program is stopped.
Select a timeout period between 1 and 99 seconds for this Ping message to reach
its destination. If the packet fails to find the IP address in this specified time, the
Ping packet will be dropped.
Enter the source IPv4 address. If the current Switch has more than one IP
address, you can enter one of them to this field. When entered, this IPv4 address
250