Table of Contents
Advertisement
4 Web-based Switch Configuration
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the Telnet protocol is 23.
Click Apply to make the configurations take effect.
System > SSH Settings
SSH configuration is Enabled by default. If user does not want to allow the SSH configuration, they only
need to disable the SSH State.
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the SSH protocol is 22.
Click Apply to make the configurations take effect.
System > D-Link Discover Protocol Settings
For the D-Link Discovery Protocol (DDP) supported device, this page is an option for user to disable DDP or
configure the DDP packet report timer.
D-Link Discover Protocol State: The default setting is Disabled.
D-Link Discover Protocol Report Timer (Seconds): Configure the report timer of D-Link Discover Protocol
in seconds. The values are 30, 60, 90, 120 or Never. The default is 30 seconds.
Click Apply to make the configurations take effect.
System > Ping Test
The Ping Test is a small program that sends ICMP Echo packets to the IP address user specified. The
destination node then responds to or "echoes" the packets sent the Switch. This is very useful to verify
connectivity between the Switch and other nodes on the network.
Figure 4.38 – System > SSH Settings
Figure 4.39 – System > D-Link Discover Protocol Settings
4
4
D-Link DGS-2000 Series Ethernet Switch User Manual
0
0
Advertisement
Table of Contents
