YASKAWA SGM7D-30F Product Manual page 494

Parameter
Name
No.
Input Signal Selections
2
12
/SEL4 (Program Step Selection Input 4) Signal Allocation

n. X
Pn632
/JOGP (Forward Jog Input) Signal Allocation
 
n. X
0 to F
/JOGN (Reverse Jog Input) Signal Allocation
 
n. X
0 to F
/JOG0 (Jog Speed Table Selection Input 0) Signal Allocation

n.X
0 to F
4.5 FT83 SERVOPACKs with Analog Voltage/Pulse Train References
Setting Setting
Range Unit
0000h to
–
FFFFh
0 Active when CN1-40 input signal is ON (closed).
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 The signal is always active.
8 The signal is always inactive.
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
The settings are the same as for /SEL4 (Program Step Selection
Input 4) Signal Allocation.
The settings are the same as for /SEL4 (Program Step Selection
Input 4) Signal Allocation.
The settings are the same as for /SEL4 (Program Step Selection
Input 4) Signal Allocation.
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
5438h All
restart
Continued on next page.
Classi- Refer-
fication ence
−
Setup
Reference
*1
Reference
*1
Reference
*1
Reference
*1
4
4-169