YASKAWA SGM7D-30F Product Manual page 348

Parameter
Name
No.
Input Signal Selections
2
4
/ZCLAMP (Zero Clamping Input) Signal Allocation

n. X
Pn50D
/INHIBIT (Reference Pulse Inhibit Input) Signal Allocation
 
n. X
/G-SEL (Gain Selection Input) Signal Allocation
 
n. X

n.X Reserved parameter (Do not change.)
4.1 FT82 SERVOPACKs with Analog Voltage/Pulse Train References
Setting Setting
Range Unit
0000h to
–
FFFFh
0 Active when CN1-40 input signal is ON (closed).
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 The signal is always active.
8 The signal is always inactive.
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
The allocations are the same as the /ZCLAMP
0 to F
(Zero Clamping Input) signal allocations.
The allocations are the same as the /ZCLAMP
0 to F
(Zero Clamping Input) signal allocations.
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
8888h –
restart
Applicable
Motors
All
Applicable
Motors
All
Applicable
Motors
All
Continued on next page.
Classi- Refer-
fication ence
Setup –
Reference
*1
Reference
*1
Reference
*1
4
4-23