YASKAWA SGM7D-30F Product Manual page 470

Parameter
Name
No.
Application Function
2
Selections B
Operator Parameter Display Selection

n. X
Motor Stopping Method for Group 2 Alarms
 
n. X
Pn00B
Power Input Selection for Three-phase SERVOPACK
 
n. X

n.X Reserved parameter (Do not change.)
Application Function
2
Selections C
Function Selection for Test without a Motor

n. X
Encoder Resolution for Tests without a Motor
Pn00C
 
n.
X
Encoder Type Selection for Tests without a Motor
 
n. X

n.X Reserved parameter (Do not change.)
Application Function
2
Selections D

n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)
Pn00D
 
n. X Reserved parameter (Do not change.)
Overtravel Warning Detection Selection

n.X
4.5 FT83 SERVOPACKs with Analog Voltage/Pulse Train References
Setting Setting
Range Unit
0000h to
–
1121h
0 Display only setup parameters.
1 Display all parameters.
0 Stop the motor by setting the speed reference to 0.
Apply the dynamic brake or coast the motor to a stop (use the
1
stopping method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
0 Use a three-phase power supply input.
Use a three-phase power supply input as a single-phase power
1
supply input.
0000h to
–
0131h
0 Disable tests without a motor.
1 Enable tests without a motor.
0 Use 13 bits.
1 Use 20 bits.
2 Use 22 bits.
3 Use 24 bits.
0 Use an incremental encoder.
1 Use an absolute encoder.
0000h to
–
1001h
0 Do not detect overtravel warnings.
1 Detect overtravel warnings.
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
0000h All
restart
After
0000h –
restart
After
0000h All
restart
Continued on next page.
Classi- Refer-
fication ence
Setup –
Reference
*1
Reference
*1
Reference
*1
*1
Setup
Applicable
Motors
All
Applicable
Motors
Rotary
Applicable
Motors
All
Setup *1
4
4-145