YASKAWA SGM7D-30F Product Manual page 482

Parameter
Name
No.
Input Signal Selections
2
1
Input Signal Allocation Mode

n. X
/S-ON (Servo ON) Signal Allocation
 
n. X
Pn50A
/P-CON (Proportional Control) Signal Allocation
 
n. X
P-OT (Forward Drive Prohibit) Signal Allocation

n.X
4.5 FT83 SERVOPACKs with Analog Voltage/Pulse Train References
Setting Setting
Range Unit
0000h to
–
FFF2h
Use the sequence input signal terminals with the default alloca-
0
tions.
1 Change the sequence input signal allocations.
2 Reserved setting (Do not use.)
0 Active when CN1-40 input signal is ON (closed).
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 The signal is always active.
8 The signal is always inactive.
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
The allocations are the same as the /S-ON (Servo ON) signal allo-
0 to F
cations.
0 Enable forward drive when CN1-40 input signal is ON (closed).
1 Enable forward drive when CN1-41 input signal is ON (closed).
2 Enable forward drive when CN1-42 input signal is ON (closed).
3 Enable forward drive when CN1-43 input signal is ON (closed).
4 Enable forward drive when CN1-44 input signal is ON (closed).
5 Enable forward drive when CN1-45 input signal is ON (closed).
6 Enable forward drive when CN1-46 input signal is ON (closed).
7 Set the signal to always prohibit forward drive.
8 Set the signal to always enable forward drive.
9 Enable forward drive when CN1-40 input signal is OFF (open).
A Enable forward drive when CN1-41 input signal is OFF (open).
B Enable forward drive when CN1-42 input signal is OFF (open).
C Enable forward drive when CN1-43 input signal is OFF (open).
D Enable forward drive when CN1-44 input signal is OFF (open).
E Enable forward drive when CN1-45 input signal is OFF (open).
F Enable forward drive when CN1-46 input signal is OFF (open).
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
8801h All
restart
Continued on next page.
Classi- Refer-
fication ence
Setup –
Reference
*1
Reference
*1
Reference
*1
Reference
*1
4
4-157