YASKAWA SGM7D-30F Product Manual page 314

3.5.8 INDEXER Warning Displays and Troubleshooting
INDEXER warning displays and corrections for them are given in the following table.
Alarm
Error No.
Number
E41E A.9F9
A.9F9
E42E
A.9F9
E43E
E44E A.9F9
A.9F9
E46E
E4BE A.9F9
A.9F9
E4CE
3.5 FT83 SERVOPACKs with Analog Voltage/Pulse Train References
Error Name
While writing data to the flash memory, a fail-
ure occurred during one of the following
operation.
Program Table
• While saving a program table by using
Save Failure Error
Fn060
• While initializing a program table by using
Fn063
While writing data to the flash memory, a fail-
ure occurred during one of the following
Zone Table Save
operation.
• While saving a zone table by using Fn061
Failure Error
• While initializing a zone table by using
Fn064
While writing data to the flash memory, a fail-
ure occurred during one of the following
operation.
JOG Speed Table
• While saving a JOG speed table by using
Save Failure Error
Fn061
• While initializing a JOG speed table by
using Fn065
There was a request to start program table
Canceled Pro-
operation even though an E19A or E1BA
alarm occurred when the control power sup-
gram Table Error
ply was turned ON.
There was a request to start JOG speed
Canceled JOG
table operation even though an E1FA or
E22A alarm occurred when the control
Speed Table Error
power supply was turned ON.
Travel in the forward direction was requested
Moving Disabled when P-OT was in effect. (Forward move-
ment is disabled when P-OT (forward over-
Error due to P-OT
travel) is in effect.)
Travel in the reverse direction was requested
Moving Disabled
when N-OT was in effect. (Reverse move-
Error due to N-OT ment is disabled when N-OT (reverse over-
travel) is in effect.)
3.5.8 INDEXER Warning Displays and Troubleshooting
Meaning Corrective Action
Repair the hard-
ware.
Repair the hard-
ware.
Repair the hard-
ware.
Remove the cause
of the alarm.
Remove the cause
of the alarm.
• When P-OT is
being used,
move to a posi-
tion where the
P-OT is not in
effect.
• When P-OT is
not being used,
disable P-OT in
the parameter.
• When N-OT is
being used,
move to a posi-
tion where the
N-OT is not in
effect.
• When N-OT is
not being used,
disable N-OT in
the parameter.
Continued on next page.
3-245
3