YASKAWA SGM7D-30F Product Manual page 489

4.5 FT83 SERVOPACKs with Analog Voltage/Pulse Train References
Parameter
No.
Pn516
Pn517
*3
Pn518
4-164
Name
Input Signal Selections
2
7
FSTP (Forced Stop Input) Signal Allocation
0 Enable drive when CN1-40 input signal is ON (closed).
1 Enable drive when CN1-41 input signal is ON (closed).
2 Enable drive when CN1-42 input signal is ON (closed).
3 Enable drive when CN1-43 input signal is ON (closed).
4 Enable drive when CN1-44 input signal is ON (closed).
5 Enable drive when CN1-45 input signal is ON (closed).
6 Enable drive when CN1-46 input signal is ON (closed).
Set the signal to always prohibit drive (always force the motor to
7

n. X stop).
Set the signal to always enable drive (always disable forcing the
8
motor to stop).
9 Enable drive when CN1-40 input signal is OFF (open).
A Enable drive when CN1-41 input signal is OFF (open).
B Enable drive when CN1-42 input signal is OFF (open).
C Enable drive when CN1-43 input signal is OFF (open).
D Enable drive when CN1-44 input signal is OFF (open).
E Enable drive when CN1-45 input signal is OFF (open).
F Enable drive when CN1-46 input signal is OFF (open).
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Output Signal Selec-
2
tions 5
ALO1 (Alarm Code Output) Signal Allocation
0 Disabled (the above signal output is not used).
1 Output the signal from the CN1-25 or CN1-26 output terminal.
2 Output the signal from the CN1-27 or CN1-28 output terminal.

n. X
3 Output the signal from the CN1-29 or CN1-30 output terminal.
4 Output the signal from the CN1-37 output terminal.
5 Output the signal from the CN1-38 output terminal.
6 Output the signal from the CN1-39 output terminal.
ALO2 (Alarm Code Output) Signal Allocation
 
n. X
The allocations are the same as the ALO1 (Alarm Code Output) signal alloca-
0 to 6
tions.
ALO3 (Alarm Code Output) Signal Allocation
 
n. X
The allocations are the same as the ALO1 (Alarm Code Output) signal alloca-
0 to 6
tions.

n.X Reserved parameter (Do not change.)
Safety Module-Related
–
Parameters
Setting Setting Default
Range Unit Setting
0000h to
– 8888h
FFFFh
0000h to
– 0000h
0666h
– – –
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
After
All Setup
restart
Reference
After
All Setup
restart
All – –
Continued on next page.
Refer-
ence
–
*1
*1
–