Plc Overview; Ladder Diagram Editor – Wplsoft - Delta C2000 series User Manual

16.1 PLC Overview

16.1.1 Introduction
The built in PLC function in C2000 allows following commands: WPLSoft, basic commands and
application commands; the operation methods are the same as Delta DVPPLC series. Other than
that, CANopen master provides 8 stations for synchronous control and 126 asynchronous controls.
NOTE
In C2000, CANopen master synchronous control complies with DS402 standard and supports
homing mode, speed mode, torque mode and point to point control mode; CANopen slave supports
two control modes, speed mode and torque mode.
16.1.2 Ladder Diagram Editor – WPLSoft
WPLSoft is a program editor of Delta DVP-PLC series and C2000 series for WINDOWS. Besides
general PLC program planning and general WINDOWS editing functions, such as cut, paste, copy,
multi-windows, WPLSoft also provides various Chinese/English comment editing and other special
functions (e.g. register editing, settings, the data readout, the file saving, and contacts monitor and
set, etc.).
Following is the system requirement for WPLSoft:
Item
Operation System
CPU
Memory
Hard Disk
Monitor
Mouse
Printer
RS-232 port
Applicable Models
Windows 95/98/2000/NT/ME/XP
Pentium 90 and above
16MB and above (32MB and above is recommended)
Capacity: 50MB and above
CD-ROM (for installing WPLSoft)
Resolution: 640×480, 16 colors and above,
It is recommended to set display setting of Windows to 800×600.
General mouse or the device compatible with Windows
Printer with Windows driver
At least one of COM1 to COM8 can be connected to PLC
All Delta DVP-PLC series and C2000 series
16-2
Chapter 16 PLC Function C2000 Series
System Requirement