Delta C2000 series User Manual page 368

Content Address
2102H Frequency command (F)
2103H Output frequency (H)
2104H Output current (AXX.X.X)
2105H DC-BUS Voltage (UXXX.X)
2106H Output voltage (EXXX.X)
2107H Current step number of Multi-Step Speed Operation
2108H Reserved
2109H Counter value
210AH Power Factor Angle (XXX.X)
210BH Output Torque (%)
210CH Actual motor speed (rpm)
210DH Number of PG feed back pulses
210EH Number of PG2 pulse commands
210FH Power output (X.XXX)
2116H Multi-function display (Pr.00-04)
211BH Max. opeartion frequency (Pr.01-00) or Max. user defined
2200H Display output current (A)
2201H Display counter value (c)
2202H Actual output frequency (H)
2203H DC-BUS voltage (u)
2204H Output voltage
2205H Power angle
2206H Display actual motor speed kW of U, V, W (P)
2207H Display motor speed in rpm estimated by the drive or encoder
2208H Display positive/negative output torque in %, estimated by the
2209H Display PG feedback (as Pr. 00-04 NOTE 1)
220AH PID feedback value after enabling PID function in % (b)
220BH Display signal of AVI analog input terminal, 0-10V corresponds
220CH Display signal of ACI analog input terminal, 4-V20mA/0-10V
220DH Display signal of AUI analog input terminal, -10V~10V
220EH IGBT temperature of drive power module in
220FH The temperature of capacitance in
2210H The status of digital input (ON/OFF), refer to Pr.02-12 (as Pr.
Chapter 12 Description of Parameter SettingsC2000 Series
Bit4~3 Operation Direction
00B: FWD run
01B: From REV run to FWD run
10B: REV run
11B: From FWD run to REV run
Bit8
1：Master frequency controlled by communication
interface
Bit9 1：Master frequency controlled by analog signal
Bit10 1：Operation command controlled by
communication interface
Bit11
1：Parameter locked
Bit12 1：Enable to copy parameters from keypad
Bit15~13 Reserved
value (Pr.00-26)
feedback
drive (t0.0: positive torque, -0.0: negative torque)
to 0-100% (1.) (as Pr. 00-04 NOTE 2)
corresponds to 0-100% (2.) (as Pr. 00-04 NOTE 2)
corresponds to -100~100% (3.) (as Pr. 00-04 NOTE 2)
00-04 NOTE 3)
153
Function
o
C
o
C