Delta C2000 series User Manual page 518

Classical field oriented control ac motor drive

Hide thumbs Also See for C2000 series:

Table of Contents

D Operands occupy three continuous points.

Please refer to the specification of each model series

for applicable range of the device.

：Binary floating point number comparison value 1. S

number comparison value 2. D: Comparison result,.three continuous points are

Comparison of the binary floating point number comparison value and binary

floating point number comparison value 2. Comparison result (＞, ＝, ＜）is

If the source operands of S

change those constants to binary floating point numbers to make comparison.

When assgined device is M10, then M10~M12 are automatically occupied.

When X0 = On, DCMP execute a command, One of M10 ~ M12 will be On. But

when X0 = Off, DECMP doen't execute any command, M10 ~ M12 remains the

same status as before X0 = Off.

If you need to have results such as ≧, ≦ or ≠, make M10~ M12 paralllel

Use the RST or ZRST command to clean the results.

Word Devices

When (D1D0)>(D101D100), M10= On

When (D1D0)=(D101D100)m ,M11= On

When (D1D0)<(D101D100)\, M11 =On

Chapter 16 PLC Function C2000 Series

Floating Point Compare

16-bit command (5 STEPS)

32-bit command

Flag signal: none

are assigned constants K or H, a command will

：Binary floating point