Delta C2000 series User Manual page 442

Display Fault code
Fault
oL
Inverter oL
Fault Fault
EoL1 EoL2
Thermal relay 2 Thermal relay 1
Fault
EoL2
Thermal relay 2
Fault Fault
EoL2 ot1
Over torque 1 Thermal relay 2
Fault Fault
EoL2 ot2
Over torque 2 Thermal relay 2
Fault Fault
EoL2 uC
Thermal relay 2 Under torque 1
Fault Fault
EoL2 cF1
Thermal relay 2 EEPROM write Err
Fault Fault
EoL2 cF2
Thermal relay 2 EEPROM read Err
Fault Fault
EoL2 cd1
Thermal relay 2 Ias sensor Err
Fault Fault
EoL2 cd2
Thermal relay 2 Ibs sensor Err
Fault Fault
cd3 EoL2
Thermal relay 2 Ics sensor Err
Overload. The AC motor drive detects
excessive drive output current.
0015H
NOTE: The AC motor drive can withstand up to
150% of the rated current for a maximum of 60
seconds.
0016H Electronics thermal relay 1 protection
0017H Electronics thermal relay 2 protection
These two fault codes will be displayed
001AH
when output current exceeds the
over-torque detection level (Pr.06.07 or
Pr.06.10) and exceeds over-torque
detection (Pr.06.08 or Pr.06.11) and it is
001BH
set 2 or 4 in Pr.06-06 or Pr.06-09.
001CH Low current
Internal EEPROM can not be
001EH
programmed.
001FH Internal EEPROM can not be read.
0021H U-phase error
0022H V-phase error
0023H W-phase error
15-29
Chapter 15 CANopen Overview C2000 Series
Description
CANopen
CANopen fault
fault code register
(bit 0~7)
2310H 1
2310H 1
2310H 1
8311H 3
8311H 3
8321H 1
5530H 5
5530H 5
FF04H 1
FF05H 1
FF06H 1