Basic Configuration - Proxim ORiNOCO AP-800 Software Management Manual

Basic Configuration

This chapter contains information on the following:
• Basic Configuration
• Factory Default Configuration
• Parameters requiring Reboot
: All the interface (radio) 2 parameters discussed in this chapter are applicable only to a dual-radio
device.
4.1 Basic Configuration
Tabulated below are the parameters to be configured to operate the AP device at a basic level:
Parameter
IP Address
Country Code
Radio Mode
Operational Mode
Current Bandwidth
®
ORiNOCO 802.11n Access Points - Software Management Guide
If you have DHCP Server on your network, then set the Address Type as Dynamic. When set
to Dynamic, the device gets its IP Address from the DHCP Server. If there is no response from
the DHCP Server, then the device will fall back to 169.254.128.132.
If you do not have the DHCP Server on your network, change the Address Type as Static. For
details on how to configure the Address Type and the IP address, refer to
Select a country from the drop down menu. For more details on how to configure the
Properties
Country Code, refer to
By default, the radio mode on both Radio1 (Interface1) and Radio 2 (Interface 2) is set to
AP. For details on how to configure the radio mode, refer to
Default Operational Mode set on both the radios, is as tabulated below:
Device Type
AP-800
AP-8000
AP-8100
For details on how to change the operational mode, refer to
By default, the current bandwidth is set to 40 MHz. For details on how to change the current
Properties
bandwidth, refer to
Description
Properties
Operational Mode
Radio 1 Radio 2
802.11g/n Not Applicable
802.11a/n 802.11g/n
802.11a/n 802.11g/n
Properties
4
IP Configuration
23