Global Configuration Mode; Configuring The Device Using Cli Commands; Commit - Proxim Tsunami MP-8100 Series Reference Manual

To list the commands in the Privileged mode, enter ?. This lists the following:

1.4.3 Global Configuration Mode

In this mode, you can configure your device. Use the 'configure' command to enter this mode.
Example:
System Name# configure
System Name(config)#
This brings the CLI into a special mode called "Global Configuration Mode", where full access permissions are given to the
user for configuring any available configuration of the device through CLI. The command prompt of this mode uses an
interactive hierarchical format which shows the configuration level the user is in and with its name.

1.5 Configuring the Device using CLI Commands

The Command Line Interface (CLI) is divided into different command modes. Each command mode has its own set of
commands that manage the network operations. The commands that you use also depend on the mode that you are in.

1.5.1 Commit

To apply the changes done, you have to commit those changes before exiting from the configure mode. To do this, use the
following commands before doing an exit from configure mode. Value for commit must be set to 1.
System Name> enable
System Name# configure
System Name(config)#commit
% Input Range <value(1)> required
System Name(config)# commit 1
Tsunami MP-8100 Reference Manual
System Name#?
Possible completions:
aad Antenna Alignment Display
clear Clear the Statistics
configure Enter Global Configuration Mode
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from EXEC
ping Send Echo Messages
show Show Running System Information
traceroute Trace Route to Destination
?
Command Line Interface
12