Using Sgda Servopack With High Voltage Line - YASKAWA SGM series User Manual

2) Connect cables of the same color to each other as shown in the table below. Note that
wiring for incremental and absolute encoders is different.
Signal
Name
PG5V
PG0V
FG
PA
PA
*
PB
PB
*
PC
PC
*
PS
PS
*
RESET
BAT
BAT0

3.8.7 Using SGDA Servopack with High Voltage Line

1) SGDA Servopacks are divided into single-phase 200 V and single-phase 100 V types
according to supply voltage.
If, however, three-phase 400 VAC class (400 V, 440 V) power supply must be used, pre-
pare the following power transformer (for single-phase).
Color and Wire Size of
Cable with Connectors
Red AWG22
Black AWG22
Green/Yellow AWG22
Blue AWG26
White/Blue AWG26
Yellow AWG26
White/Yellow AWG26
Green AWG26
White/Green AWG26
Violet AWG26
White/Green AWG26
White/Gray AWG26
Orange AWG26
White/Orange AWG26
<Primary side>
1) 400 or 440 VAC
2) 400 or 440 VAC
Color and Wire Size of
50-meter Extension
Cable (DP8409179)
Red AWG16
Black AWG16
Green/Yellow AWG16
Blue AWG26
White/Blue AWG26
Yellow AWG26
White/Yellow AWG26
Green AWG26
White/Green AWG26
Purple AWG26
White/Green AWG26
White/Gray AWG26
Orange AWG26
White/Orange AWG26
<Secondary side>
200 VAC
100 VAC
3.8 Special Wiring
3
Only the absolute
encoder can be
connected.
159