Installing The Servomotor; Before Installation; Storage - YASKAWA SGM series User Manual

Servo-
pack

2.2.2 Installing the Servomotor

Servomotor SGM and SGMP types can be installed either horizontally or vertically. However,
if the Servomotor is installed incorrectly or in an inappropriate location, the service life will be
shortened or unexpected problems will occur. To prevent this, always observe the installation
instructions described below.

Before installation:

Anticorrosive paint is coated on the edge of the motor shaft. Clean off the anticorrosive
paint thoroughly using a cloth moistened with thinner.
NOTE Avoid getting thinner on other parts of the Servomotor when cleaning the shaft.

Storage:

When the Servomotor is to be stored with the power cable disconnected, store it in the
following temperature range:
Between −20°C and 60°C
Installation sites:
The Servomotor SGM and SGMP types are designed for indoor use.
Install Servomotor in an environment which meets the following conditions:
SFree from corrosive and explosive gases
Appearance
Σ-Series SGDA
Servopack
Nameplate
Servopack type
Σ-Series
SGDA Servopack
Rated Ouoput
A3:0.04HP A5:0.07HP
01:0.13HP 02:0.27HP
03:0.40HP 04:0.53HP
08:1.01HP
Power Supply
Type
Serial number
S: For speed/torque control
P: For position control
Output power voltage
Applicable motor
Applicable power supply
Blank: SGM Servomotor
P: SGMP Servomotor
Anticorrosive paint is
coated here
2.2 Installation
Type
2
19