3-6
Configuring TCP/IP addresses
4.
5.
6.
NOTE
Figure 3-1
IP address byte location sample
Network ID
IP Address: 192.168.0.2
Subnet mask: 255.255.255.0
Select the fourth byte (Node identifier). Use an easily recognizable pattern if assigning
numbers to many nodes (see
Select the Subnet mask for the network class (see
Set the Model 2701 address(es) as required.
addresses" on page 3-7.
Since the network scheme in
gateway address selected does not matter (it can be set to 0.0.0.0).
IP Address: 192.168.0.50
Subnet mask: 255.255.255.0
Node designation
Model 2701 Instrument Networking Instruction Manual
Figure
3-1).
Table
(See "Changing Model 2701 TCP/IP
Figure 3-1
does not connect to a corporate LAN, the
IP Address: 192.168.0.2
Subnet mask: 255.255.255.0
IP Address: 192.168.0.3
Subnet mask: 255.255.255.0
IP Address: Made up of two parts:
• Network ID: Must be the same for
all nodes on the network that are
communicating with each other.
• Node designation: Must be different
from each node on the network but
within the parameters of the networks
class and subnet mask.
Subnet mask: Must be the same for
all nodes on the network that are
communicating.
3-2).