Configure Fabric Parameters Dialog Box - HP storageworks director 2/140 Service Manual

Diagnostics
2. At the Hardware View, choose Configure > Operating
Figure 29: Configure Fabric Parameters dialog box
3. Choose the operating mode as follows:
4. Click Activate to save the selection and close the window.
Did configuring the Management Style solve the problem?
NO
↓
Contact the next level of support. Exit MAP.
22
A loopback plug is connected to the port and there is no diagnostic test running. Is
a loopback plug in the port receptacle?
YES
↓
23
Remove the loopback plug from the port receptacle. If directed by the customer,
connect a fiber optic jumper cable attaching a device to the director.
126
Parameters > Fabric Parameters. The Configure Fabric Parameters dialog
box displays, as shown in
Choose Open Fabric 1.0 from the Interop Mode list box.
Choose Homogeneous from the Interop Mode list box.
YES
The director is operational. Exit MAP.
NO
Contact the next level of support. Exit MAP.
If the port is operational and a device is not attached, both LEDs adjacent to
the port extinguish and the port state is No Light.
Figure 29.
Director 2/140 Service Manual