HP storageworks director 2/140 Service Manual page 155

6
Reboot the HAFM appliance and perform system diagnostics.
1. Choose Start > Shut Down. The Shut Down Windows dialog box displays.
2. Choose Shut down from the drop-down list and click OK to power off the
3. Wait approximately 30 seconds and press the power ( ) button on the liquid
4. After successful POST completion, the LCD panel displays a Welcome!!
5. After rebooting the appliance at the LCD panel, log on to the HAFM
Director 2/140 Service Manual
appliance.
crystal display (LCD) panel to power on the appliance and perform power-on
self-test (POST). During POST:
a. The green LCD panel illuminates.
b. The green hard disk drive (HDD) LED blinks momentarily, and processor
speed and random-access memory information display momentarily at the
LCD panel.
c. After a few seconds, the LCD panel displays a message, as shown in
Figure 8.
d. Ignore the message. After ten seconds, the appliance performs the boot
sequence from the basic input/output system (BIOS). During the boot
sequence, the appliance performs additional POST tests and displays the
following operational information at the LCD panel:
— Host name.
— System date and time.
— LAN 1 and LAN 2 IP addresses.
— Fan 1, fan 2, fan 3, and fan 4 rotational speed.
— Central processing unit (CPU) temperature.
— Hard disk capacity.
— Virtual and physical memory capacity.
message, then continuously cycles through and displays appliance operational
information.
appliance Windows 2000 desktop through a LAN connection to a
browser-capable PC. The HAFM application starts and the HAFM 8 Log In
dialog box displays, as shown in Figure 9.
Diagnostics
155