RRP: UPM Filler Blank
Use the following procedures to remove or replace a UPM filler blank. Filler
blanks cover and protect unused UPM card slots in the director chassis. A list of tools
required is provided.
Tools Required
The torque tool and hex adapter (provided with the director) is required to perform
these procedures.
Removing the Filler Blank
To remove a filler blank:
1. If the director is installed in a stand-alone configuration, go to
2. Identify the filler blank to be removed.
3. The filler blank is secured to the director chassis with two captive Allen
4. Insert the torque tool (1) into each locking Allen screw in the filler blank (2).
5. Pull the filler blank out and remove it from the director chassis.
Director 2/140 Service Manual
director is rack-mounted, unlock and open the cabinet front door as directed
by the HP authorized service provider.
screws. Both screws are spring-loaded to lock the filler blank in place.
Turn each screw counterclockwise until the spring releases and the tool turns
freely, as shown in
Figure
76.
FRU Removal and Replacement
step
2. If the
239