HP storageworks director 2/140 Service Manual page 102

Diagnostics
7. Configure the Port Settings parameters as follows:
8. At the > prompt, type the user-level password (the default is password) and
9. At the C> prompt, type the ipconfig command and press the Enter key. The
10. Record the director's IP address.
11. Choose File > Exit. A HyperTerminal dialog box displays.
12. Click Yes. A second HyperTerminal dialog box displays.
13. Click No to exit and close the HyperTerminal application.
14. Power off the maintenance terminal.
15. Disconnect the RS-232 null modem cable from the director and the
Continue to the next step.
22
Define the director's correct IP address to the HAFM appliance.
1. At the HAFM main window, choose Discover > Setup. The Discover Setup
102
Bits per second—57600.
Data bits—8.
Parity—None.
Stop bits—1.
Flow control—Hardware.
When the parameters are set, click OK. The Director 2/140 HyperTerminal
window displays.
press the Enter key. The password is case sensitive. The Director 2/140
HyperTerminal window displays with a C> prompt at the bottom of the
window.
Director 2/140 HyperTerminal window displays with configuration
information listed (including the IP address).
maintenance terminal. Replace the protective cap over the maintenance port.
dialog box displays, as shown in Figure 23.
Director 2/140 Service Manual