HP storageworks director 2/140 Service Manual page 243

6. At the Hardware View, choose Logs > Event Log. The Event Log displays.
7. Perform one of the following to verify power supply operation:
8. At the Hardware View, double-click the graphic representing the
9. Perform the data collection procedure
10. Perform one of the following to clear the system error (ERR) LED:
11. If necessary, close and lock the equipment cabinet door.
Director 2/140 Service Manual
Ensure an event code 207 (power supply installed) displays in the log.
If an event code 207 does not display in the log, go to
MAP" on page 45 to isolate the problem.
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate a power supply failure. If a
problem is indicated, go to
the problem.
replacement power supply to open the FRU Properties dialog box. Verify that
information (FRU name, position, and state) is correct. If a problem is
indicated, go to "MAP 0000: Start
page 192).
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
— If at an EWS interface:
a. Click the Switch tab at the Operations panel. The Operations panel
displays with the Switch page open.
b. Click the Sys Err Light tab. The Switch page displays with the Sys
Err Light tab selected. A System Error Light is ON
message displays on the page.
c. Click Clear Light.
FRU Removal and Replacement
"MAP 0000: Start MAP" on page 45 to isolate
MAP" on page 45 to isolate the problem.
("Collecting Maintenance
"MAP 0000: Start
"MAP 0000:
Data" on
243