HP storageworks director 2/140 Service Manual page 275

Table 31: HAFM Messages (Continued)
Cannot modify a zone
with an invalid name.
Rename zone and try
again.
Cannot modify
product.
Cannot perform
operation. Fabric is
unknown.
Cannot perform
operation. The list of
attached nodes is
unavailable.
Cannot retrieve current
SNMP configuration.
Cannot save current
SNMP configuration.
Cannot set write
authorization without
defining a community
name.
Director 2/140 Service Manual
Message
A zone must have a
valid name to be
modified.
The selected product
cannot be modified.
This message displays
if no switches in the
fabric are connected
to the HAFM
appliance.
This message displays
when attached nodes
are unavailable and
you attempt to modify
a zone or create a
new zone.
The current SNMP
configuration could
not be retrieved.
The current SNMP
configuration could
not be saved.
An SNMP community
name has not been
configured.
Description
Assign a valid name to the
zone, then modify the name
through the Modify Zone Set
dialog box.
Verify the HAFM
appliance-to-product link is up.
If the link is up:
Ensure at least one
fabric-attached switch or
director has an Ethernet
connection to the HAFM
appliance and retry the
operation.
Verify an attached node is
available and retry the
operation.
Try again. If the problem
persists, contact the next level
of support.
Try again. If the problem
persists, contact the next level
of support.
Enter a valid community name
in the Configure SNMP dialog
box.
Information and Error Messages
Action
The HAFM appliance may
be busy.
Another Element Manager
instance may be open.
You may not have
permission to modify the
product.
275