HP storageworks director 2/140 Service Manual page 230

FRU Removal and Replacement
9. Inspect the CTP card to ensure the amber LED is extinguished. If the amber
10. At the Hardware View, choose Logs > Event Log. The Event Log displays.
11. Perform one of the following to verify CTP card operation:
12. At the Hardware View, double-click the graphic representing the
13. Perform the data collection procedure
14. If the customer requests the replacement CTP card be set as the active card,
15. Perform one of the following to clear the system error (ERR) LED:
230
LED is illuminated, go to
problem.
Ensure the following event codes display in the log:
— 410—CTP card reset.
— 416—Backup CTP installed.
— 422—CTP firmware synchronization complete (only if the firmware
versions on the two CTP cards are different).
If the event codes do not display in the log, go to
page 45 to isolate the problem.
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate a CTP card failure. If a problem is
indicated, go to "MAP 0000: Start
problem.
replacement card to open the FRU Properties dialog box. Verify that CTP
card information (FRU name, position, and state) is correct. If a problem is
indicated, go to "MAP 0000: Start
page 192).
perform a FRU switchover. At the Hardware View, right-click the graphic
representing the replacement card to open a menu, then choose Switchover.
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
"MAP 0000: Start MAP" on page 45 to isolate the
MAP" on page 45 to isolate the
MAP" on page 45 to isolate the problem.
("Collecting Maintenance
"MAP 0000: Start MAP" on
"MAP 0000:
Data" on
Director 2/140 Service Manual