HP storageworks director 2/140 Service Manual page 299

Table 32: Element Manager Messages (Continued)
Cannot set switch date
and time.
Cannot set switch
state.
Cannot set write
authorization without
defining a community
name.
Cannot start data
collection.
Cannot start firmware
install while CTP
synchronization is in
progress.
Cannot start port
diagnostics.
Cannot swap an
uninstalled port.
Click OK to remove all
contents from log.
Director 2/140 Service Manual
Message
The switch date and
time cannot be set at
the Element Manager
because the Ethernet
link is down or busy.
The director or switch
state cannot be set at
the Element Manager
because the Ethernet
link is down or busy.
A community name
was not defined in the
Configure SNMP
dialog box for the
write authorization
selected.
The data collection
procedure cannot be
started by the Element
Manager because the
Ethernet link is down
or busy.
The director's CTP
cards are
synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Port diagnostics
cannot be started at
the Element Manager
because the Ethernet
link is down or busy.
A port swap cannot be
performed when the
port card is not
installed.
This action deletes all
contents from the
selected log.
Description
Retry the operation later. If the
condition persists, contact the
next level of support.
Retry the operation later. If the
condition persists, contact the
next level of support.
Provide a name in the Name
field where write authorization
is checked.
Retry the operation later. If the
condition persists, contact the
next level of support.
Install the firmware after CTP
card synchronization
completes.
Retry the operation later. If the
condition persists, contact the
next level of support.
Perform a swap only on a port
that is installed.
Click OK to delete the log
contents or click Cancel to
cancel the operation.
Information and Error Messages
Action
299