HP storageworks director 2/140 Service Manual page 259

5. Using a standard Phillips screwdriver, tighten the 7 panhead screws that secure
6. Connect the maintenance port cable.
7. Replace the card cage and backplane in the director chassis. with 6 panhead
8. Plug the Power/System LED assembly cable into the backplane.
9. Replace the SBAR assemblies
10. Replace the fan modules
11. Replace the AC modules
12. Replace the power supplies
13. Replace the UPM cards
14. Replace the CTP cards
15. Disconnect the ESD wrist strap from the director chassis and your wrist.
16. Replace the RFI shield.
17. Connect the power cords and power on the director
18. Verify that POSTs complete and the green power LED on the front bezel,
19. Reprogram the replacement backplane with the original director serial
Director 2/140 Service Manual
the backplane to the card cage. Tighten the screws alternately from bottom to top
and from side to side.
Phillips screws. Use a standard Phillips screwdriver to replace the 6 panhead
Phillips screws.
page 247).
page 195).
green LED on the active CTP card, and green PWR OK LEDs on both power
supplies remain illuminated. If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
number:
a. Remove the protective cap from the 9-pin maintenance port at the rear of
the director (a flat-tip screwdriver may be required). Connect the 9-pin
end of the RS-232 null modem cable to the 9-pin maintenance port on the
director.
b. Connect the other cable end to a 9-pin communication port (COM1 or
COM2) at the rear of the maintenance terminal PC.
c. Power on the maintenance terminal and establish a HyperTerminal
connection. Use the following settings:
— Kilobits per second—115.2
("RRP: Redundant SBAR
("RRP: Redundant Fan
("RRP: AC Module" on page 244).
("RRP: Redundant Power
("RRP: UPM Card" on page 231).
("RRP: Redundant CTP
FRU Removal and Replacement
Assembly" on
Module" on page 250).
Supply" on page 241).
Card" on page 226).
("Power-On Procedure" on
"MAP 0000:
259