HP storageworks director 2/140 Service Manual page 252

FRU Removal and Replacement
3. Position the fan module at the rear of the director chassis, as shown in
4. Using a standard flat-tip screwdriver, tighten the two captive screws that
5. Disconnect the ESD wrist strap from the director chassis and your wrist.
6. Inspect the fan module to ensure the amber LED is extinguished. If the LED is
7. Replace the RFI shield.
8. At the Hardware View, choose Logs > Event Log. The Event Log displays.
9. Perform one of the following to verify fan module operation:
10. At the Hardware View, double-click the graphic representing the
11. Perform the data collection procedure
12. Perform one of the following to clear the system error (ERR) LED:
252
Figure 80. Using the rear of the fan module as a handle, push the module
toward the backplane to engage the connector pins. Support the fan module
with one hand when performing this step.
secure the fan module to the director chassis.
illuminated, go to "MAP 0000: Start
Ensure an event code 321 (fan FRU inserted) displays in the log.
If an event code 321 does not display in the log, go to
MAP" on page 45 to isolate the problem.
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate a fan module failure. If a problem
is indicated, go to
problem.
replacement fan module to open the FRU Properties dialog box. Verify that
information (FRU name, position, and state) is correct. If a problem is
indicated, go to "MAP 0000: Start
page 192).
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
MAP" on page 45 to isolate the problem.
"MAP 0000: Start MAP" on page 45 to isolate the
MAP" on page 45 to isolate the problem.
("Collecting Maintenance
"MAP 0000: Start
"MAP 0000:
Data" on
Director 2/140 Service Manual