HP storageworks director 2/140 Service Manual page 72

Diagnostics
9
Verify director operation:
1. Inspect the director front bezel and ensure the green power LED illuminates.
2. Inspect both power supplies. Ensure both green PWR OK LEDs illuminate
3. At the Hardware View, observe all graphics representing FRUs and power
Is a failure indicated?
YES
↓
Contact the next level of support. Exit MAP.
10
Is fault isolation being performed at the director?
YES
↓
11
Verify the director is connected to facility power and is powered on.
1. Ensure AC power cords (PS0 and PS1) are connected to the rear of the
2. Ensure associated facility circuit breakers are on. If not, ask the customer to
3. Ensure the AC power cords are not damaged. If damaged, replace the cords.
4. Ensure the power switch (circuit breaker) at the rear of the director is set to
Continue to the next step.
72
Inspect the active CTP card and ensure the green LED illuminates.
and all amber LEDs extinguish.
supplies, and ensure emulated green LEDs illuminate.
NO
The director is operational. Exit MAP.
NO
Fault isolation is being performed at the HAFM appliance or
Embedded Web Server interface. Go to
director and to facility power receptacles. If not, connect the cords as directed
by the customer.
set the circuit breakers on.
the ON (up) position.
step 21.
Director 2/140 Service Manual