HP storageworks director 2/140 Service Manual page 157

9
Perform one of the following:
Did diagnostic test programs detect a problem?
NO
↓
10
Reboot the HAFM appliance.
1. Choose Start > Shut Down. The Shut Down Windows dialog box displays.
2. Choose Shut down from the drop-down list and click OK to power off the
3. Wait approximately 30 seconds and press the power ( ) button on the liquid
Director 2/140 Service Manual
If the appliance has standalone diagnostic test programs resident on the hard
drive, perform the diagnostics. Refer to supporting documentation shipped
with the appliance for instructions.
If the appliance does not have standalone diagnostic test programs resident on
fixed disk, go to step
YES
Refer to the supporting documentation shipped with the appliance for
instructions to resolve the problem. Exit MAP.
appliance.
crystal display (LCD) panel to power on the appliance and perform power-on
self-test (POST). During POST:
a. The green LCD panel illuminates.
b. The green hard disk drive (HDD) LED blinks momentarily, and processor
speed and random-access memory information display momentarily at the
LCD panel.
c. After a few seconds, the LCD panel displays a message, as shown in
Figure 8.
d. Ignore the message. After ten seconds, the appliance performs the boot
sequence from the basic input/output system (BIOS). During the boot
sequence, the appliance performs additional POST tests and displays the
following operational information at the LCD panel:
— Host name.
— System date and time.
— LAN 1 and LAN 2 IP addresses.
— Fan 1, fan 2, fan 3, and fan 4 rotational speed.
10.
Diagnostics
157