HP storageworks director 2/140 Service Manual page 249

8. At the Hardware View, choose Logs > Event Log. The Event Log displays.
9. Perform one of the following to verify SBAR operation:
10. At the Hardware View, double-click the graphic representing the
11. Perform the data collection procedure
12. If the customer requests the replacement SBAR assembly be set as the active
13. Perform one of the following to clear the system error (ERR) LED:
Director 2/140 Service Manual
Ensure the following event codes display in the log:
— 600—SBAR card hot-insertion initiated.
— 601—SBAR card hot-insertion completed.
If an event code 601 does not display in the log, go to
MAP" on page 45 to isolate the problem.
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate an SBAR failure. If a problem is
indicated, go to "MAP 0000: Start
problem.
replacement SBAR assembly to open the FRU Properties dialog box. Verify
that information (FRU name, position, and state) is correct. If a problem is
indicated, go to "MAP 0000: Start
page 192).
SBAR, perform a FRU switchover. At the Hardware View, right-click the
graphic representing the replacement assembly to open a menu, then choose
Switchover.
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
— If at an EWS interface:
a. Click the Switch tab at the Operations panel. The Operations panel
displays with the Switch page open.
FRU Removal and Replacement
"MAP 0000: Start
MAP" on page 45 to isolate the
MAP" on page 45 to isolate the problem.
("Collecting Maintenance
"MAP 0000:
Data" on
249