Element Manager Messages - HP storageworks director 2/140 Service Manual

Information and Error Messages

Element Manager Messages

This section lists Element Manager information and error messages in
alphabetical order.
Table 32: Element Manager Messages
A Preferred Path
already exists between
this Source Port and
this Destination
Domain ID. Please
re-configure the
desired path.
Activating this
configuration will
overwrite the current
configuration.
All configuration
names must be unique.
All FPM ports will be
held inactive while the
director is configured
to 2 Gb/sec speed. Do
you want to continue?
All port names must be
unique.
All port names must be
unique.
An Element Manager
instance is already
open.
292
Message
For any source port,
only one path may be
defined to each
destination domain ID.
Confirmation to
activate a new address
configuration.
All address
configurations must be
saved with unique
names.
Occurs when FPM
cards are installed in
the director and
director speed is being
set to 2 Gb/sec in the
Configure Switch
Parameters dialog
box.
A duplicate Fibre
Channel port name
was configured. All
port names must be
unique.
A duplicate port name
was entered. Every
configured port name
must be unique.
Only one instance of
the Element Manager
can be open at one
time.
Description
On the Add/Change Preferred
Path dialog box, change the
preferred path.
Click Yes to confirm activating
the new address configuration
or No to cancel the operation.
Save the configuration with a
different name that is unique to
all saved configurations.
Replace FPM cards with UPM
cards (UPM cards operate at 1
and 2 Gb/sec) or set the
director speed to 1 Gb/sec.
Reconfigure the Fibre Channel
port with a unique name.
Reconfigure the port with a
unique name.
Close the open Element
Manager so the desired
instance of the Element
Manager can be opened.
Action
Error Messages