HP storageworks director 2/140 Service Manual page 229

4. Secure the CTP card:
5. After the replacement CTP card is installed, note the following:
6. Verify that synchronization is complete by viewing the Event Log.
7. Connect the Ethernet LAN cable to the RJ-45 connector on the faceplate of
8. Disconnect the ESD wrist strap from the director chassis and your wrist.
Director 2/140 Service Manual
a. Insert the torque tool into the cam Allen screw at the top of the card. Turn
the torque tool clockwise until you feel it release and hear a clicking
sound. As the screw turns clockwise, the card cams into the backplane
connector.
b. Insert the torque tool into the locking Allen screw at the bottom of the
card. Turn the torque tool clockwise until you feel it release and hear a
clicking sound. As the screw turns clockwise, the card locks into place.
c. Verify the card stiffener is flush with the front of the card cage and even
with other director logic cards.
— When a CTP card with a different firmware version is installed in a
director with an active CTP card, a synchronization process occurs. This
process causes firmware from the active CTP card to be downloaded to
the replacement CTP card. The process does not occur if both CTP cards
have the same firmware version.
— The synchronization process may take up to ten minutes (depending on
director activity).
Caution: Allow the synchronization process to complete. If the process is
interrupted by a director power cycle or initial program load (IPL), or by
removing the replacement CTP card, the card may be unusable due to
partially-loaded firmware.
— If after ten minutes the replacement CTP card is not operational, perform
the data collection procedure and return the failed replacement card to HP
("Collecting Maintenance
— Do not reinstall the failed replacement CTP card, because this can corrupt
director firmware. Obtain a new CTP card and perform this replacement
procedure.
the replacement CTP card.
Data" on page 192).
FRU Removal and Replacement
229