HP storageworks director 2/140 Service Manual page 312

Information and Error Messages
Table 32: Element Manager Messages (Continued)
Port cannot swap to
itself.
Port diagnostics
cannot be performed
on an inactive port.
Port speeds cannot be
configured at a higher
rate than the director
speed.
Port numbers must be
in the range of 0 to
xxx.
Preferred Paths can
not be enabled until
the Domain ID is set to
Insistent. Disable
Preferred Paths, then
configure Switch
Parameters.
R_A_TOV must be
greater than
E_D_TOV.
Resource is
unavailable.
Resource is
unavailable.
312
Message
Port addresses entered
in the Swap Ports
dialog box are the
same.
This displays when
port diagnostics is run
on a port in an
inactive state.
This displays when you
configure a port to 2
Gb/sec and the
director speed is set to
1 Gb/sec.
When configuring
Preferred Paths, source
ports and exit ports
must be in the range of
ports for the switch
being configured.
If the switch's domain
ID has not been set to
Insistent, the user is not
allowed to activate the
Preferred Path
configuration with the
Enable Preferred Paths
check box selected.
R_A_TOV must be
greater than
E_D_TOV.
The specified
operation cannot be
performed because the
product is unavailable.
The specified
operation cannot be
performed because the
product is unavailable.
Description
Ensure that address in the first
and second Port Address fields
are different.
Run the diagnostics on an
active port.
Set the director speed to 2
Gb/sec in the Configure Switch
Parameter dialog box.
In the Configure Preferred
Paths dialog box, change the
numbers in the Source Port and
Exit Port fields to fall within the
port count of the switch on
which you are configuring
paths.
Close the Configure Preferred
Paths dialog box and click
Configure > Operating
Parameters > Switch
Parameters. In the Configure
Switch Parameters dialog box,
click the Insistent check box.
Change one of the values so
that R_A_TOV is greater than
E_D_TOV
Verify that the Ethernet
connection between the HAFM
appliance and the director is
up or available.
Verify that the HAFM
appliance-to-product link is up.
If the link is up, the HAFM
appliance may be busy. Try the
operation again later.
Action
Error Messages