Rrp: Sfp Optical Transceiver; Tools Required; Removing The Sfp Optical Transceiver - HP storageworks director 2/140 Service Manual

FRU Removal and Replacement

RRP: SFP Optical Transceiver

Use the following procedures to remove or replace an SFP optical transceiver
from a UPM card. A list of tools required is provided.

Tools Required

The following tools are required to perform these procedures.

Removing the SFP Optical Transceiver

To remove an SFP optical transceiver:
1. Notify the customer that the port with the defective transceiver will be
2. If the director is installed in a stand-alone configuration, go to
3. Identify the defective port transceiver from the amber LED on the UPM card
4. Block communication to the port
5. Disconnect the fiber optic jumper cable from the port:
6. Depending on the manufacturer, the optical transceiver may have a locking
236
fiber optic protective plug (provided with the director).
Protective cap (provided with the fiber optic jumper cable).
fiber optic cleaning kit.
blocked. Ensure the customer's system administrator sets the attached device
offline.
director is rack-mounted, unlock and open the cabinet front door as directed
by the HP authorized service provider.
or failure information at the HAFM appliance's Port Card View.
a. Pull the keyed LC free from the port's optical transceiver.
b. Place a protective cap over the cable connector.
mechanism to secure the transceiver in the port receptacle, or the transceiver
may have a pull tab to assist in removal.
a. If required, disengage the locking mechanism by squeezing the
mechanism or pushing it toward the port receptacle.
b. Grasp the pull tab or the optical transceiver frame and pull the transceiver
(1) from the port receptacle, as shown in
("Block a Port" on page 202).
Figure 75.
Director 2/140 Service Manual
step 3. If the