The switch is configured for Open Fabric mode but the switch or switch at the other
end of the ISL is not configured to Open Fabric mode, or switch is connected to a
non-HP switch and the interop mode is set to homogeneous fabric mode.
Configure the switch operating mode:
a. Ensure the switch is set offline
b. At the Hardware View for the selected switch, click Configure and select Fabric
Parameters. The Configure Fabric Parameters dialog box displays
Figure 2–14: Configure Fabric Parameters Dialog Box
c. Select the operating mode as follows:
Select the Interop Mode radio button to set the switch to open systems operating
mode, then select Homogeneous Fabric 1.0 or Open Fabric 1.0 from the
Interop Mode list box.
Select the homogeneous fabric option if the switch is fabric- attached only to
other HP switches or switches that are also operating in Homogeneous Fabric
1.0 mode. Select the open fabric option if the switch is fabric-attached to switches
or switches produced by other original equipment manufacturers (OEMs) that are
d. Click Activate to save the selection and close the window.
Did configuring the operating mode solve the problem?
The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
edge switch 2/24 service manual
(Set the Switch Online or Offline on page