Replacing The Fan Module; Fan Module Removal And Replacement - HP storageworks director 2/140 Service Manual
Hide thumbs
Also See for storageworks director 2/140:
- Product manager manual (244 pages) ,
- Installation manual (128 pages) ,
- Release note (27 pages)
Table of Contents
Advertisement
1
Figure 80: Fan module removal and replacement
6. Using the rear of the fan module as a handle, pull the module from the
7. Place the fan module in an antistatic bag to provide ESD protection.
Replacing the Fan Module
To replace the fan module:
1. Remove the replacement fan module from its protective antistatic bag.
2. Inspect the PWA on the underside of the fan module for bent or broken
Director 2/140 Service Manual
1
Fan module
Caution:
Do not remove a fan module unless the replacement module is
available. Operation of the director with only one fan module for an
extended period may cause one or more thermal sensors to post event codes.
director. Support the fan module with one hand when performing this step.
connector pins that may have been damaged during shipping. If any pins are
damaged, obtain a new fan module.
FRU Removal and Replacement
251
Advertisement
Table of Contents
