Map 0200: Event Codes - HP storageworks director 2/140 Service Manual

2
Was an event code 400, or 411, or 413 observed at the director Event Log (HAFM
appliance) or at the Embedded Web Server Event Log?
YES
↓
3
Table 7
that describe fault isolation procedures.
Table 7: MAP 0200: Event Codes
Event Code
400
411
413
4
POST/IPL diagnostics detected a FRU failure as indicated by an event code 400
with supplementary event data.
1. At the Hardware View, choose Logs > Event Log. The Event Log displays.
2. Examine the first two bytes (0 and 1) of event data.
3. Byte 0 is a FRU code that indicates the failed component. Byte 1 is the slot
Director 2/140 Service Manual
NO
Analysis for the failure is not described in this MAP. Go to
0000: Start MAP" on page 45. Exit MAP.
lists event codes, brief explanations of the codes, and the associated steps
Power-up diagnostic failure.
Firmware fault.
Backup CTP card POST
failure.
number of the failed FRU (00 for a nonredundant FRU, 00 or 01 for redundant
FRUs, and 00 through 15 for UPM cards).
Table 8 lists byte 0 FRU codes and associated steps that describe fault
isolation procedures.
Explanation Action
Go to step 4
Go to step 11
Go to step 12
Diagnostics
"MAP
79