HP storageworks director 2/140 Service Manual page 328

Event Code Tables
Event Data: The first byte of event data (byte 0) specifies the E_Port number. The fifth byte (byte
4) specifies the segmentation reason as follows:
1 = Incompatible operating parameters. Ether the resource allocation time out value
(R_A_TOV) or error detect time out value (E_D_TOV) is inconsistent between the
Director 2/140 and another fabric element (director or switch). Modify the
R_A_TOV and E_D_TOV to make the values consistent for all fabric directors and
switches.
2 = Duplicate domain ID. The Director 2/140 has the same preferred domain ID as
another fabric element (director or switch). Modify the director's Domain ID to
make it unique.
3 = Incompatible zoning configurations. The same name is applied to a zone for
the Director 2/140 and another fabric element (director or switch), but the zones
contain different zone members. Modify the zone name to make it unique, or
ensure zones with the same name contain identical zone members.
4 = Build fabric protocol error. A protocol error was detected during incorporation
of the Director 2/140 into the fabric. Disconnect the E_Port link, then reconnect the
link. If the condition persists, perform the data collection procedure and return the
backup CD to HP support personnel.
5 = No principal switch. No director or switch in the fabric can become the
principal switch. Modify the switch priority to any value other than 255.
6 = No response from attached switch (hello timeout). The Director 2/140
periodically verifies operation of attached fabric elements (directors or switches).
The director E_Port (at the operational director) times out and segments if the
attached device does not respond. Check the status of the attached director or
switch. If the condition persists, perform the data collection procedure (at the
attached device) and return the backup CD to HP support personnel.
7 = ELP retransmission failure timeout. A Director 2/140 that exhibits a hardware
or link failure attempted to join a fabric and transmitted multiple exchange link
protocol (ELP) frames to a fabric element (director or switch). However, because of
the problem, the director did not receive responses to the ELP frames, and did not
receive a fabric login (FLOGI) frame. After five ELP transmission attempts, the
director E_Port (failed director) times out and segments. Go to
MAP" on page 45 to perform hardware fault isolation at the failed director.
328
"MAP 0000: Start
Director 2/140 Service Manual