HP storageworks director 2/140 Service Manual page 238

FRU Removal and Replacement
5. Inspect the UPM card with the replacement port transceiver to ensure all
6. At the Hardware View, choose Logs > Event Log. The Event Log displays.
7. Perform one of the following to verify UPM card operation:
8. Restore communication to the port with the replacement transceiver as
9. Perform one of the following to clear the system error (ERR) LED:
10. If necessary, close and lock the equipment cabinet door.
238
amber LEDs are extinguished. If any amber LEDs are illuminated, go to
"MAP 0000: Start MAP" on page 45 to isolate the problem.
Ensure an event code 510 (SFP optics card hot-insertion initiated) displays in
the log.
If an event code 510 does not display in the log, go to
MAP" on page 45 to isolate the problem.
— At the Hardware View, observe the graphic representing the replacement
card and ensure no alert symbols display that indicate a failure (yellow
triangle or red diamond). If a problem is indicated, go to
Start MAP" on page 45 to isolate the problem.
— At the EWS interface, open the Switch tab at the View panel and ensure
no amber LEDs illuminate that indicate a UPM card failure. If a problem
is indicated, go to
problem.
directed by the customer
the port is available for use.
— If at the HAFM application, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a FRU) to open
a menu.
b. Click Clear System Error Light.
— If at an EWS interface:
a. Click the Switch tab at the Operations panel. The Operations panel
displays with the Switch page open.
b. Click the Sys Err Light tab. The Switch page displays with the Sys
Err Light tab selected. A System Error Light is ON
message displays on the page.
c. Click Clear Light.
"MAP 0000: Start MAP" on page 45 to isolate the
("Unblock a Port" on page 203). Inform the customer
"MAP 0000: Start
"MAP 0000:
Director 2/140 Service Manual