HP storageworks director 2/140 Service Manual page 276

Information and Error Messages
Table 31: HAFM Messages (Continued)
Cannot show zoning
library. No fabric
exists.
Click OK to remove all
contents from log.
Connection to
management server
lost.
Connection to
management server
lost. Click OK to exit
application.
Could not export log to
file.
Default zoning is not
supported in Open
Fabric Mode.
Device is not a
member of a zone in
the active zone set.
276
Message
You cannot show the
zoning library if no
fabric exists. You must
have identified a
switch or director to
the
for a fabric to exist.
This action deletes all
contents from the
selected log.
The connection to the
remote HAFM
appliance has been
lost.
The
at a remote
workstation lost the
network connection to
the HAFM appliance.
A log file input/output
(I/O) error occurred
and the file could not
be saved to the
specified destination.
The disk may be full or
write protected.
A default zone cannot
be enabled when the
product is enabled for
Open Fabric mode.
Open Fabric mode
does not support zone
members defined by
port numbers.
The selected device is
not a member of a
zone in the active zone
set and therefore
cannot communicate
with the other devices
in the route.
Description
HAFM
application
HAFM
application
Action
Identify an existing switch or
HAFM
director to the
application using the New
Product dialog box.
Click OK to delete the log
contents or Cancel to cancel the
operation.
Log in to the HAFM appliance
again through the HAFM Log In
dialog box.
HAFM
Re-start the application
to connect to the HAFM
appliance.
If the disk is full, use another
disk. If the disk is write
protected, change the
write-protect properties or use
another disk.
Change the Interop Mode from
Open Fabric to Homogeneous
using the Configure Fabric
Parameters dialog box. You
can also redefine zone
members by the device WWN.
Enable the default zone or
activate a zone set containing
the member before attempting
to show the route.
Error Messages